Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
The kitchen furniture in which the appliance is installed must be heat resistant to at least 90°C. This also applies
to the doors or front of the furniture.
•
Make sure that the kitchen furniture in which the appliance is installed is firmly attached, for example by fastening
the furniture to adjacent elements.
•
In case of incorrect installation or connection the warranty becomes invalid.
•
Changes to the appliance, including replacing the mains cable, must be carried out by a certified installer.
•
Make sure that there is sufficient ventilation and fresh air around the appliance.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.
PREPARING FOR INSTALLATION
(Figure 3)
Note:
Make sure that the kitchen furniture is prepared according to the dimensions of the appliance.
INSTALLING THE APPLIANCE
Preliminary requirements
•
Make sure that the kitchen furniture is prepared according to the correct dimensions.
Warning:
Two persons are required to install the appliance.
Caution:
Make sure that the mains cable does not get jammed during installation or is placed on top of the
appliance.
Caution:
Do not cover the opening between the kitchen furniture and the top of the appliance. The opening is
required for ventilation.
Note:
It is possible to connect the appliance to the mains supply before positioning the appliance.
Procedure
1. Put the appliance (A) in the center of the kitchen furniture.
Caution:
Make sure that there is a minimum space of 2 mm between the appliance and the walls of the kitchen
furniture.
2. Open the door (D) of the appliance.
3. Install the appliance in the kitchen furniture. Use the screws (C).
4. Install the covers (B).
5. Close the door.
6. Connect the appliance. Refer to section
Connecting the appliance
.
(Figure 4)
English
•
35
Werbung
