Strax xqisit LZ380 Kurzanleitung

EN
Dear Customer
Thank you for purchasing the LZ380 Bluetooth wireless
headphones. Please read this manual carefully and
follow the intructions in order to optimize the use of
your new headphones and enjoy your music the way it
was meant to be heard.
INCLUDES
LZ380 Bluetooth Headphones
3,5 mm premium flat cable
Protective carrying case
Cleaning cloth
USB cable
TECHNICAL DATA
• Impedance: 32 Ohm
• Frequency: 20HZ-20KHz
• Performance: 200 mW
• Maximum input power: 1000 mW
• Cable length: 1.2 m
• Plug Type: 3.5 mm
• Allowance ambient operating temperature: -10 to +70°C
• Dimensions: 202x190x70mm
• Weight: 200 g
• Bluetooth Version: 2.1 + EDR
• Bluetooth profiles: A2DP, AVRCP, HSP, HFP
• Range: up to 10m
• Battery: 3.7V, 350 mAh Li-ion battery
• Charging time: 120 Minutes for a full charge
• Play/Talk time: Up to 10 h
INSTRUCTIONS
1. Turning on and off
To turn on, press and hold the power button until LED
starts flashing blue. To turn off, press and hold the
power button until LED flashes purple once.
2. Pairing and connecting the headset
Make sure that LZ380 is turned off. Press and hold the
power button for about 6 seconds until the LED starts
to flash red and blue. Activate the Bluteooth feature on
your device and set it to search for Bluetooth devices.
LZ380 will be displayed on your BT device, select it for
pairing. "0000" is the pairing code if necessary.
Remark: pairing steps are only needed for first-time
connection; automatic connection is allowed on most
BT devices except Apple® devices.
Double check with your BT device to see if "LZ380" is
connected.
3. Music playback
Press the power button to pause and play music.
4. Voice Call
Press the power button to answer a phone call, press
the power button again to end the call. Press the power
button twice to call the last number in your phone call
records.
5. Touch gesture control
Slide and hold your finger vertically on the right side of
the headphone panel to adjust the volume: bottom to
top sliding = volume up, top to bottom sliding = volume
down. Sliding your finger horizontally on the right side
of the headphone panel allows you to jump between
songs: front to back sliding = previous song, back to
front sliding = next song.
6. Low power warning
Once the battery power is running low you will hear „du
du du" warning, repeating every 3 minutes to remind
you that your headset needs to be charged.
7. Charging
DC 5V 230+/-20mA,
Charge LZ380 whenever it is needed: plug into computer
via the USB cable. The LZ380 may also be charged via a
power-to-USB adapter (not included).
During charging the LED is red.
Remark: for best user experience fully charge LZ380 at
least once a month.
8. Connection via 3.5 mm jack
For devices without Bluetooth functionality use a 3.5 mm
jack cable to connect your device with the LZ380.
When using a 3.5 mm jack the LZ380 can be controlled
only by your input device. Here handsfree is not
supported.
Power
Touch panel
Charging plug
3.5 mm jack