Tilt Function - geo-FENNEL FL 550H-G Bedienungsanleitung

EN

TILT FUNCTION

Switching on the laser the TILT function will be activated automatically. „TILT" is flashing during the acti-
vation procedure. When the activation is completed (after 90 sec approx.) „TILT" is shown in the display
permanently.
Press the button to switch this function on/off.
When the TILT function is active:
If the laser is disturbed, the rotation stopps and the laser beam and „TILT" will flash. The laser will not
re-level automatically.
If required the self-levelling procedure can be re-activated with button .
This instrument has three TILT status:
Activation
=„TILT" flashes slowly during the activation procedure, the instrument in not yet ready for use
Function active
= TILT" is indicated permanently
TILT alarm
= „TILT" is flashing quickly and the rotation stopps
VIBRATION-WIND-SECURITY (VWS-FUNCTION)
Press this button to activate the VWS mode. The VWS function automatically activates the TILT function.
This function allows continuous operation during periods of vibration and wind. If a significant movement
occurs the laser stops rotating and the TILT LED starts flashing. Press the VWS button to quit. Press the
VWS button again to re-activate.
SLEEP/MANUAL FUNCTION
Press the button once to enter into the SLEEP mode. The instrument and the remote control are now in
standby mode. All values set will be stored. After restart the instrument will work with the same vales as
before.
Note: After 60 min. in standby function the laser automatically switches off.
Press the button again to re-active the instrument and the remote control.
Press the button long to enter into the MANUAL mode.
Now the laser can be used in slope postion without the instrument switching off automatically and
without re-levelling.
25