Miele PDR 514 Kurzgebrauchsanweisung Seite 135

Programme run-
ning time/Time left
estimation
Energy saving
End of the pro-
gramme
Removing the
laundry
The Start/Stop sensor control will light up.
Programme sequence
- If Delay start has been selected, the Delay start time will start to
count down first.
- The programme starts.
The programme running time depends on the quantity of laundry, the
type of fabric and the residual moisture in the laundry. The displayed
programme running time for drying level programmes can therefore
vary or "jump". The tumble dryer's electronic module adapts during
the ongoing drying programme. The displayed programme running
time becomes more and more accurate.
When using the programmes for the first time, the displayed time
sometimes deviates significantly from the real time left. The differ-
ence between the estimated and achieved time becomes smaller if
the corresponding programme is run more often. If different load
sizes are dried in one programme, the time left display can only show
an approximate time.
Laundry items and fabrics can wear out unnecessarily.
Avoid overdrying the laundry.
After a programmed time, the indicators dim. The Start/Stop sensor
control flashes slowly.
Touch the Start/Stop sensor control to switch the indicators back

on.
Energy saving for the indicators will not affect a running programme.
- The laundry is cooled before the end of the programme in line with
the setting in the programmable function.
5. Unloading laundry from the tumble dryer
The tumble dryer can be configured so that a buzzer sounds at the
end of the programme.
At the end of the programme ( is indicated on the time display),
the laundry has cooled down and can be removed.
If Anti-crease has been selected, the drum keeps rotating at intervals.
This reduces creasing if the laundry cannot be removed straight away.
The tumble dryer will switch off automatically after the programmed
time after the end of a programme.
Open the door.

en - Drying
135