Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Utilisation as not submersed pump (see picture 2)
Place the pump deeper than the water surface near the pond, so that the water can flow to the pump.
The pump is not self-priming.
Take off the filter basket; connect the pump inlet and the pump outlet with hoses.
Before running the pump the inlet hose has to be filled with water.
To avoid clogging the pump a suction filter should be attached to the suction hose.
Commissioning
After reading the installation instructions carefully, you can start the new pump if you note the following
aspects:
Check if the pressure pipes have been installed properly.
Make sure that the electrical connection is 230V~50Hz.
Check if the socket is in proper working order.
Make sure that moisture or water never reaches the mains connection.
Avoid that the pump operates dry.
Warranty Information
Not covered by warranty:
Damaging the mechanical seal due to dry running or pumping cleaning agents or other chemical
substances.
Damages in transit
Damages caused by unauthorised interference
Parts subjects to wear (propeller, sealing flange) do not fall under warranty.
Hints for maintenance!
The pond motor pump is a maintenance-free and a practice-proven quality product that was subjected
to rigorous final inspections. For a long working life and continuous operation we recommend regular
checking and proper care.
Maintenance and Cleaning
Overload protection:
The pump has an integrated overheat protection. After the pump is stopped it has to cool down for a
while due to the overheat control device, before it runs again. In case it does not run again by itself,
the following checks shall be conducted:
Could the pump cool down sufficiently due to the overheat protection after being stopped?
Is the water supply sufficient?
Is the filter clogged?
Is there dirt in the pump housing?
Is the hose or the pipe clogged?
Is the hose broken, too long?
Maiintenance and cleaning of the pump picture 2 + 3:
Disconnect the pump!
Standard maintenance
1. Follow these safety measures. Make sure that the pump is unplugged.
2. Press the filter cover together laterally and take it out of the pump.
3. Loosen the outer screws.
4. Unclip the pump housing from motor housing.
5. Remove the rotor assembly from motor housing.
6. Clean all parts using water and soft sponge.
Putting the pump back together:
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
>
Improve the water supply!
>
If necessary rinse the filter!
>
Perform cleaning!
>
Clear the hose/pipe!
>
Check, replace, shorten!
Seite 17
Werbung
