Create WINECOOLER XXL Bedienungsanleitung Seite 11

This unit has the capability of either opening the door from the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reserve the
opening direction, please follow these instructions:
Note: Before reversing the door, the power must be shut off. All parts removed must be
saved to the reinstallation of the door.This unit has been built with the door hinges on the
right. If you wish to change the opening direction, follow the instructions below:
1. Remove the upper hinge cover first.
2. Remove the three screws that hold the upper hinge (right side) to the frame. Take away the
upper hinge (right side).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws that hold the lower hinge and make sure to remove the hinge.
5. Remove the left front leg and transfer it to the right side.
6. Remove the hole cover plate to the right side.
7. Before placing this lower hinge, remove the bolt in it and reverse the direction of the
lower hinge. Then install the lower hinge onto the left side of the lower frame with two
screws.
8. Insert the bolt into the lower hinge.
9. Set the door to its place making sure the door seats on the lower hinge.
10. While holing the door in the closed position secure the upper hinge in the top frame of left side
with three screws. Please remember to not tighten the three screws until the top of the door is
leveled with the counter top.
11. Install the upper hinge cover.
• Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
• Turn off the wine cooler first and then unplug the unit from the wall outlet.
• Remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda
solution.
• The solution should be about 2 tablespoons of baking soda to a quart of water.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
• The outside of the wine cooler should be cleaned with mild detergent and warm water.
• Dry the interior and exterior with a soft cloth.
• Dust or anything else blocking the vent may hinder the cooling efficiency of the appliance.
Vacuum the vent if necessary.
• Turn off the wine cooler first and then unplug the unit from the wall outlet when it is not
going to be used for a long period of time.
• Remove all the contents.
• Clean the appliance.
• Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
• Short vacations: Leave the wine cooler operating during vacations of less than three
weeks.
• Long vacations: If the wine cooler will not be used for several months, remove all content
and unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold
growth, leave the door open slightly: blocking it open if necessary.
REVERSING THE DOOR SWING
CLEANING AND MAINTENANCE
E NGLI SH
11