Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.)
5.)
6.)
7.)
Rotary switch below the monitor.
Switch upward to turn the unit on.
Next rotate upward to turn on the
lighting LEDs placed on the
Power ON
camera. Turn knob up and down
to dim the LEDs or completely
turn down to turn the power off
again.
Plug the flexible camera with the
guidance in the holder provided.
Turn the nut on the thread of the
Camera
camera to fix the attachment. To
Connection
release the camera, turn the nut
in the opposite direction and pull
the camera back from the
connector.
Press the trigger to activate the
flashlight. This additional lighting
is switched independently from
Flashlight
the camera lighting, which is
regulated over the dimmer (item
4: Power ON). To switch off the
flashlight, press the trigger again.
Carefully slide the cap forward
until it jumps to the top of the
guide rail. Remove dead
batteries and insert new batteries
into the battery compartment.
Battery
Pay attention to the correct
polarity as shown in the
illustration
-19-
Werbung
Inhaltsverzeichnis
