bürkert TopControl 8630 Betriebsanleitung Seite 99

6.4 Configuration of the additional functions
NOTE The operating concept of the positioner is based on a separate basic and additional functions. Only the basic
functions of the unit are activated on delivery. This enables the basic settings such as specific units to be set
during the initial setting up of the unit (Chapter 4). These are sufficient for the normal operations.
For more demanding tasks of position and process control, additional functions can be selected and
configurated.
6.4.1 Keys in the configuration menu
Key description
Key description
6.4.2 Configuration menu
Process mode
MANUAL
Fig. 5.6: Switch between process mode and configuration mode
5 s
The configuration menu is constituted of the main menu and the additional menu. The main menu will contain the functions as
specified during the initial commissioning (Chapter 4). The additional menu contains complementary functions and is available
through the ADDFUNCT menu within the main menu. If necessary, you may complete the main menu with functions from the
additional sub-menu, which you can then specify.
Top Control Positioner
within the Menu
Arrow up key
Arrow down key
within the Menu
Validation of the selected
sub-menu
Validation of the selected value
AUTO-
MATIC
Within process mode, press the MANUAL/AUTOMATIC key and hold down for 5 sec to activate the
configuration mode.
within a selected sub-menu
Increase of the numeric value
Decrease of the numeric value
within the menu ADDFUNCT
Validation of the selected sub-menu of the additional
functions for use within the main menu. The sub-menu
is marked with a star (*) within the main-Menu and can
there be selected and modified.
Selection of the selected submenu (marked with a star) in
order to suppress it from the main menu.
Configuration mode
5 s
Basic func-
tions
END
Additional
menu
99