Hyundai VK306 Bedienungsanleitung Seite 18

III. INSTRUCTIONS FOR USE
Fill the kettle with clean cold water up to max., turn it on and let the water boil before first use.
Then Pour the water out and repeat the process several times (at least five times).
APPLICATIONS
Unwind the necessary length of the power cord B2 from the storage space of the stand B. Plug the
fork of the power cord to the electric socket. Hold the kettle A on the handle A4. old the kettle A
on the handle A4. Open the lid A5. Fill the kettle with drinking water. The minimum and maximum
amount of water is marked on the water gauge A3. Close the lid. Put the electric kettle on the
stand and turn it to the I position by the A1 button. Function of the electric kettle is signaled with
the control light A2. After boiling the appliance switches off automatically. Before reaching the
boiling point, you can switch off the appliance by turning the A1 button to the O position. Always
use fresh drinking water for boiling.
• When heating the water, the lid must be correctly positioned on the kettle (closed),
otherwise the kettle will not switch off!
• In the case of tilting the electric kettle with hot water there is a risk of scalding.
Therefore do not tilt the electric kettle.
• Recommendation: When the kettle is not used, do not place it on the stand connected
to the mains.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The housing of
the kettle is made of high-quality plastic, the heating bottom and inner surface of the kettle are made
of high-quality stainless steel, however, a slight sediment (scale) during standard use /particularly,
above the heating element/ cannot be avoided. It is not rust or another material defect of the kettle
container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
In the hard water area, it is important to do the decalcification regularly to keep the kettle in good
working condition, because too much scale inside may cause the kettle fail to work. For the best
performance of your kettle, decalcify the unit from time to time. The frequency depends on the
hardness of your tap water and how many times you have used the kettle. Decalcification will
clean the interior of the unit.
This may be done in the following manner:
Put about 50 g of citric acid into the kettle with limescale sediment. Fill the kettle half with water
and stir. After dissolving, fill it up to ¾ of maximum amount of water. Place the kettle on the
stand and turn on. Turn off the kettle before reaching boiling point, let the solution work for 10
minutes and then pour it out. Rinse the kettle thoroughly with clean water. In case of very thick
sediments, you can repeat the process. Clean the kettle regularly!
Expert service must do the large maintenance or to intervene into inside parts of the
appliance! Non-observance of the instructions of the manufacturer cancels the right for
guarantee repair!
ATTENTION
EN - 18