Climadiff PRO161XDZ Gebrauchsanweisung Seite 35

 Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
 Adequate ventilation is required, do not block the front air outlet.
 The appliance is for indoor use only.
 This unit is not designed to be installed in an RV or used with an inverter.
 This appliance is designed to be installed built-under or free standing.
 This appliance is intended to be used exclusively for the storage of wine.
 This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
 Connect the appliance to a single socket, leaving a 10 cm gap between the back of the wine cooler
and the wall. Be careful to support it, so that your wine cooler is perfectly level (the use of a spirit level
is recommended). This will prevent any movement due to instability, generating noise and vibration,
and will ensure that the door seals perfectly.
Attention
 Store wine in sealed bottles.
 Do not overload the cabinet.
 Do not open the door unless necessary.
 Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
 Should the wine cooler be left empty for long periods it is suggested that the appliance is unplugged,
and after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to
avoid possible condensation, mold or odors forming.
CAUTION: please keep the appliance away from substance, which can cause ignition.
Ambient room temperature limits
This appliance is designed to operate in ambient temperatures specified by its temperature class marked
on the rating plate.
CLASS
Extended temperate
Temperate
Subtropical
Tropical
Reversing the door
Please be noted that the door is not reversible as control is directly put on the door itself.
Installation of your wine cooler
This appliance is designed to be installed built-under or free standing. For a built-under installation,
please have a look on the drawing here below.
 The depth of the cabinet (opening) should be at least 73cm and the width 61cm.
 If installing between frameless cabinets, a ¼cm wide filler strip or side panel (not provided with your
wine cooler) may be needed on the hinge side.
 The filler strip will act as a spacer between the appliance case and adjacent cabinet door swing.
SYMBOL AMBIENT TEMPERATURES RANGE (°C)
SN
N
ST
T
From +10 to +32
From +16 to +32
From +16 to +38
From +16 to +43
35