Dreame VTE1 Benutzerhandbuch Seite 28

Troubleshooting
I the vacuum is not working properly, the screen display will show an error message. Please
reer to the troubleshooting table to nd your solution.
Error Icon
WEEE Inormation
All products bearing this symbol are waste electrical and electronic equipment (WEEE
as in directive 2012/19/EU) which should not be mixed with unsorted household
waste. Instead, you should protect human health and the environment by handing
over your waste equipment to a designated collection point or the recycling o
waste electrical and electronic equipment, appointed by the government or local
authorities. Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. Please contact the installer
or local authorities or more inormation about the location as well as terms and
conditions o such collection points.
24
Error Message
Battery overheating
Roller brush stuck
Air duct blocked
Error
Solutions
Please wait and continue to use after
motor temperature is normal.
Refer to the maintenance guide
[Cleaning the Smart Multi-Brush Bar]
section to clean the fiber material and
hairs wrapped around the roller brush.
Check whether the dust cup, filter,
pre-filter, extension rod, and smart
multi-brush bar are blocked. Refer to
the maintenance section to clean.
Allow dry thoroughly before reuse.
Please contact our after-sales service
department for maintenance.