BROSZIO BUZZ SAW D42 Bedienungsanleitung Seite 43

5. Operating switch
Power on: First, open the machine main switch, the engine starts running and then open the protective covering
self-locking switch, press down the machine to start cutting a work piece.
Switch off: Release the on/off switch.
6. Dust suction connection
It is recommended to use the dust suction outlet. You can buy a suitable commercial dust suction device or
suc"8. Laser adjustment
ust through a dust suction pipe.
7. Brush change
CAUTION: Before working on the machine, make sure that the switch is in the „OFF" position and the mains
power plug is unplugged.
Use a flat-head screwdriver to remove the two coverings of the brush housing. Remove the two carbon brushes
and dispose of these. Note: The brushes must always be replaced as pairs.
Insert the new brushes, replace the coverings and tighten these with the screwdriver. The new brushes may first
generate sparks until they match the profile of the motor. Repeat the process on the other side
8. Laser adjustment
When using the laser for the first time, check that the laser axis is correctly
positioned. If not, use an Allen wrench to adjust the laser location."
9. Use of the laser aiming device
Never look directly into the laser beam.
Injuries could be the result if you look directly into the laser. Please
note the following rules: Turn on the laser at the side (Fig. 1)
Align the laser to the end point of the planned cut. (Fig. 2)
When sawing, guide the saw along the visible light beam.
Fig. 1 Fig. 2
GB
PAGE 43