Operation; Spindle Speed; Table - Holzmann SB 3116RHN Betriebsanleitung

13.2

Operation

With the ON/OFF / EMERGENCY unit, the machine is switched on and off. For this, the
EMERGENCY-STOP-cap must be unlocked. Note: Press the switch only after you have chosen the
direction of rotation and spindle speed.

13.2.1 Spindle speed

The exact cutting speeds are given in the specifications of the drill manufacturers. Basically the
following rule of thumb applies:
As smaller the hole, as higher the rotation speed.
To achieve a good result is also:
1. Lift the PULLEY COVER.
2. Loosen the Thumb Nut. The BELT TENSION should release.
3. Move the V-belt to the desired level (speed) on the pulleys.
4. Push the Motor backward and hold. Retighten the Thumb Nut.
5. Close the Belt PULLEY COVER.

13.2.2 Table

1. Loosen the Support Clamp.
2. Turn the Crank to move the Table to the desired
height.
3. Tighten the Support Clamp.
4. To tilt the Table, loosen Hex Bolt and turn the
Table. The scale can be used to approximate the
angle. Tighten the Hex Bolt.
HOLZMANN MASCHINEN GmbH
 Soft material => high rotation speed
 Hard material => low rotation speed
www.holzmann-maschinen.at
N O T I C E
OPERATION
45
SB 3116RHN / SB 3116RMN