Werbung
1) Remove the camera screw MM
(Fig. 4-1)
2) Remove the Lift Up Lever Spring ait. (Fig. 4-1]
3) Remove the Push Lever Ass'y a
from the support
by
pushing
it into
direction
A indicated
by an arrow
(Fig. 4-2) to an overstroke position and slide Case Lifter
a
to the left (into direction
B — B' indicated by
an arrow in tne
Fig, 4-2, (At this time, the Push Lever
should be kept pressed.)
mw Camera Screw
(Fig.4-1)}
5.M.G PLATE ASS'Y DISASSEMBLY
1) Remove the Main Beit Qu. (Fig. 5-1)
2) Remove the two camera screws (M2 x 3.5) (9) . (Fig,
9-1)
3) Remove
the
&-Ring
uy and
dislocate
the F.R Actu-
ator Qi) _ (Fig. 5-1)
}) Main Belt
®
Camera Screw
(38) M.G Plate Ass'y
(Fig. 51)
Push Lever Ass'y rh}
CQ-878EG
4) Untock the Chassis Ass'y {ff andthe C.D Plate 9p.
(It comes off from the Chassis Ass'y by clockwise rota-
tion (into direction C indicated by an arrow in the Fig.
4-2). Slowly put the Push
Lever back in its place and
down
the Cassette
Case
BM
Push the Push
Lever
up
again, and the cassette case comes
up, remove
by lift.
ING iT.
OB
Plate
2 3
is Case Lifter
du Cassette Case
y
= 203 Chassis Assy
(Fig. 4-2)
4) Remove the M.G Plate Ass'y 9. (Fig. 5-2)
Note:
1) This work
is much
easier in the Eject state
than in the Reverse Play state.
2) Installation
work
is much
easier
when
the
Control!
Spring
an
and
Collar
Screw
a
(Fig. 52), T.G Actuator ri} and E-Ring G04.
Main
Plate Ne
E-Ring
0p and —-Ring
304
are removed. (Fig. 5-3)
—- 45 Collar
~
Screw
M.G Plate Ass'y OS
\_
Contra
7
~
Spring
(Fig. 5-3)
Aes
Werbung
