Werbung
AFTER EACH INFLATION
Deflate and re-arm, as described in "Re-arming," P.9.
ANNUALLY
Perform the following at the beginning of each boating season, after
inflation, or whenever the integrity of the flotation device is in doubt:
1.
Check all components for dirt or corrosion (see "Inspecting
Components," P.3). Clean or replace, as necessary.
2. Visually examine your flotation device for damage or excessive
abrasion, wear, tear, or contamination. Particular attention must
be paid to the stitching, straps, and hardware. If in doubt, contact
Mustang Survival customer service for evaluation and/or servicing.
3. Perform the Leak Test (see "Care and Maintenance/Every Six
Months," P.19).
4. Deflate as outlined in "Deflating," P.8.
5. Ensure green indicator pin is installed in the manual inflator.
6. Record the date, noting "annual" in permanent ink on the Care
and Storage label, located on the bladder.
CLEANING AND STORING YOUR PFD
To clean your PFD, hand wash or sponge down in warm, soapy water,
taking care not to submerge the inflator. Rinse your PFD with clean
water and hang to dry on a plastic coat hanger. Do not dry-clean, use
chlorine bleach, or apply direct heat. Always store your fully dried
PFD in a warm, dry, well-ventilated place out of direct sunlight.
WHY ARE PFDS REQUIRED SAFETY EQUIPMENT?
Drownings are the leading cause of fatalities involving recreational
and commercial vessels. A PFD provides flotation to help keep your
head above water to help you to stay face up in the water, and
increase your chances for survival and rescue. Most adults only need
an extra 50N or so of flotation to keep their heads above water. The
proper size PFD will properly support the weight of the wearer. Since
this inflatable PFD does not have inherent buoyancy, it provides
flotation only when inflated. Familiarize yourself with the use of this
PFD so you know what to do in an emergency.
20
Werbung
