Use; Switching On The Appliance; Adjusting The Sweeping Performance - Dirt Devil Duplex Bedienungsanleitung

4 Use

4 Use
ATTENTION:
Check with the manufacturer of your flooring to see whether it is suited to being cleaned with an
electric brush sweeper.

4.1 Switching on the appliance

0 0
I
10

4.2 Adjusting the sweeping performance

I I
II
11
1. Place the appliance down on the floor.
2. Pull the tube towards you, thereby bend-
ing down the brush base. The brush base
should now be on the floor however you
hold the tube.
3. Switch on the brush sweeper by moving
the slider switch to the 'I' position (Fig. 10).
- The brush rollers rotate at the medium
speed.
NOTE:
This should be sufficient for sweeping hard
floors. To sweep short-pile carpets, push
the slider switch further down to position 'II'.
The appliance is designed to sweep short-
pile carpets (e.g. carpet pile no longer than
5 mm) alone. The appliance does not work
on longer carpet piles.
NOTE:
When the appliance is running you can
switch between switch settings 'I' and 'II' as
much as you like (Fig. 11).
NOTE:
We recommend using the medium setting
(I) so that you can use a battery charge for
as long as possible.
NOTE:
If the battery power has reduced markedly
or the brushes will no longer rotate, the bat-
tery pack has to be charged ZChapter 3.4,
'Charging the battery pack'.
31