SCH.E.I.D.L Energy Controller Montageanleitung Seite 17

SCH.E.I.D.L Energy Controller
Scheme measuring data logger
The SCH.E.I.D.L Energy Controller is
connected centrally between the
network and your Heating System.
This allowes access from your
private network and also encrypted by
the public Internet (red arrows).
The sensors are connected via plug
and can be plugged in chains behind
the other (black arrows):
• T1 is a room temperature sensor
to check the heating times
• T2 checks a solar thermal system
to overheat (after T1)
• T3 is demonstrated on the return
of a heating circuit to improve the
efficiency of a condensing boiler
• T4 is an outside air sensor to see
the heating requirements
• Accessories: E1 is an electricity
meter for the consumption of a
heat pump, or the generation of a
CHP
• Accessories: P­T1 to T3 P­3 are
Installation Manual Data­Logger
temperature sensor on a buffer to
show losses in the system and
l eaks
Internal architecture
The entire system is based on a
secure Linux operating system. The
Logic permanently reads a new
sensor values ​ ​ f rom the Bus and
stores it in the Database. The
Webserver allows direct access to
stored data by a browser. The
Hardware Detection detects the bus
new sensors and install them
Connection and architecture
automatically. The Security Network
allows access only if you log in and
encrypts each network access in a
tunnel.
EN
Page 17 of 40