Brandt BMG2508B Bedienungsanleitung Seite 147

2 / INSTALLATION
Installation and connection
1. This appliance is only intended for
domestic use.
2. This oven is intended for built-in use
only. It is not intended for counter-top
use or for use inside a cupboard.
3. Please observe the special installation
instructions.
4. The appliance can be installed in a
60cm wide wallmounted cupboard.
5. The appliance is fitted with a plug and
must only be connected to a properly
installed earthed socket.
6. The mains voltage must correspond to
the voltage specified on the rating
plate.
7. The socket must be installed and
connecting cable must only be replaced
by a qualified electrician. If the plug is
Installation Instructions
Please Read the Manual Carefully Before Installation
ADJUST SCREW A
SCREW B
TRIM-KIT PLASTIC COVER
no longer to accessible following
installation, an all-pole disconnecting
device must be present on the
installation side with a contact gap of at
least 3mm.
8. Adapters, multi-way strips and
extension leads must not be used.
Overloading can result in a risk of fire.
The accessible surface may be hot
during operation.
EN 15