IFM Electronic AS Interface AC1008 Bedienungsanleitung Seite 28

Locking/unlocking modes > 4
1
(operating step 0/1)
2
3
(= acknowledgment)
Unlocking: Press both buttons for approx. 5s; as acknowledgment
digit 1 is flashing in the LED display.
Error messages
28
PAGE
Select mode
Mode Set
Press twice
Mode Set
Press once
Display of missing/defective slaves
(digit 2 = master; digits 3 and 4 = slave no.);
the slaves are displayed at intervals of seconds.
The list of failed slaves can be stored until the slaves
have been replaced.
- Press the SET button twice (for the list of master 1)
or SET -MODE - SET (for the list of master 2). The
lowest address of the error list is displayed flashing.
- Replace the failed slave by a slave with the same
configuration and with the address 0; it will receive
the indicated address; (the function "automatic
addressing" must be activated). If other addresses
are displayed, proceed in the same way until the list
has been completed.
- The function will be ended when the slaves have
been replaced or the SET button has been pressed.
Display of the selected mode
Display of locking flashing
Display locking active