vivi M026SH Bedienungsanleitung Seite 8

3.1 Loosen the headlight screw from the front fork; install the headlight in the
front fork screw hole, and tighten the screw with an Allen tool.
4. Front wheel installation
4.1 Cut the wrapping rope, remove the front wheel, remove the front fork
protection lever and the front wheel protection cover.
4.2 Make sure that the front wheel is in line with the rare wheel, then
start installation. First pull the wheel upwards, put the disc brake pad into
the front brake caliper, and then use 15 wrench to tighter the front hub
fixing screw.
4.3 Adjust the adjusting screw of the disc brake to make the disc brake
rotor without obvious friction
5.Foot pedal installation:
Check the two pedals. The pedal with "L" printed on the end of the mandrel
should be installed on the left side of the vehicle (without chain ring), rotate
counterclockwise, and the "R" pedal should be installed on the right side.
(With chain ring), rotate clockwise, and then use a No. 15 wrench Tighten the
pedal spindle.
6