Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTING
CORDS
Fig.
|
Fig.
CONNECTING
SPEAKER
CORDS
CONNECTING
INPUT/OUTPUT
1.
Strip off the vinyl covering and twist the tip of the wire core.
CORDS
2.
St ue the knob and insert the wire core into the terminal
Connect the white plug to the L (left) side, and the red plug to the
ee
R (right) side. Be sure to push the plugs in securely.
3.
Tighten the knob to fix the wire core in place.
NOTE:
Speaker Impedance
TROUBLESHOOTING
No power supplied to unit
* Power plug is disconnected from outlet.
* Insert plug securely in outlet.
* The component's power plug has been
¢ Turn on power to other component.
plugged into another component's power
outlet (e.g. timer, etc), but power to that
unit is disconnected.
Connecting cords are disconnected from
Connect securely.
terminals, or connected incorrectly.
* Terminals, or connecting cords' pin plugs
are dirty.
:
* The INPUT SELECTOR or ADPT 1/TAPE
3 switch
selected
do
not
match
the
component
being played back.
Operation of other components is incorrect.
No sound
Clean terminals and plugs.
* Set switches correctly (PHONO, TUNER,
CD, LINE. DAT/TAPE 1, TAPE 2). Set the
ADPT 1/TAPE 3 to OFF.
* Consult the operating instructions for the
other components.
Set the switch to "A". "B" or 'A + B".
¢ The SPEAKERS selector switch is set to
"OFF"
¢ The PHONO EQ switch is "OFF" position
(When listening PHONO
in A-717).
Set PHONO
EQ switch to "ON" position.
No sound
from one speaker
Connecting
cords or speaker cords are
Connect
securely.
disconnected
on that side.
¢ BALANCE control has been adjusted to
Adjust BALANCE control to center position.
one side.
The
position
of the
REC
SELECTOR
switch
is incorrect.
* Connections are incorrect.
Operation of tape deck is incorrect.
Set switch correctly
(See section "RECORDING
TAPES').
* Re-connect properly.
* Consult the operating instructions for the
tape deck.
Can't record tapes
The
position
of the
REC
SELECTOR
switch is incorrect.
Operation of tape decks is incorrect.
Set switch correctly
(See section "COPYING
TAPES').
* Consult the operating instructions for the
tape decks.
Can't perform tape copying
8
<ARE1064>
Werbung
Inhaltsverzeichnis
