Ventilation Requirements - ZANKER KRAK12ES Benutzerinformation

Overall dimensions ¹
H1 mm
W1* mm
D1 mm
¹ the height, width and depth of the appliance
without the handle
* including the width of the bottom hinges (8
mm)
Space required in use ²
H2 (A+B) mm
W2* mm
D2 mm
A mm
B mm
² the height, width and depth of the appliance
including the handle, plus the space
necessary for free circulation of the cooling
air
* including the width of the bottom hinges (8
mm)
Overall space required in use ³
H3 (A+B) mm
W3* mm
D3 mm
³ the height, width and depth of the appliance
including the handle, plus the space
necessary for free circulation of the cooling
air, plus the space necessary to allow door
opening to the minimum angle permitting
removal of all internal equipment
* including the width of the bottom hinges (8
mm)
3.2 Location
To ensure appliance's best functionality, you
should not install the appliance in a place with
direct sunlight. Do not install the appliance
close to radiators or cookers, ovens, or hobs,
unless otherwise specified in the installation
instructions.
Make sure that air can circulate freely around
1218
the back of the cabinet.
548
This appliance should be installed in a dry,
well ventilated indoor position.
549
This appliance is intended to be used at
ambient temperature ranging from 10°C to
43°C.
The correct operation of the
appliance can only be guaranteed within
the specified temperature range.
1261
If you have any doubts regarding
where to install the appliance, please turn
548
to the vendor, to our customer service or
551 to the nearest Authorised Service Centre.
1225
It must be possible to disconnect the
36
appliance from the mains power supply.
The plug must therefore be easily
accessible after installation.
3.3 Electrical connection
• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power
supply.
• The appliance must be earthed. The
power supply cable plug is provided with a
1261
contact for this purpose. If the domestic
power supply socket is not earthed,
548
connect the appliance to a separate earth
1071
in compliance with current regulations,
consulting a qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.

3.4 Ventilation requirements

The airflow behind the appliance must be
sufficient.
ENGLISH 7