IPC Benz-C Bedienungsanleitung Seite 101

CLOTHING AND EQUIPMENT
Wear safety shoes with non-slip soles.
Wear protective goggles or visor and safety
garments.
You are recommended to wear overalls to reduce the risk of
injury caused by involuntary contact with the high pressure jet.
Depending on the surface being cleaned and the environment,
the protective measures necessary for pulverised mists may
include respiratory masks with class FFP2 or equivalent or
higher protection.
USING
THE CLEANER
STARTING THE CLEANER
Turn on the water supply tap
(fig. 4A).
1) Place the petrol tap lever in
the open ON position (fig. 6A).
2) Place the starting lever in
the starter position (fig. 6B). If
the engine is hot, this step is
not required.
3) Place the engine switch in
the ON position (fig. 7).
4) Start up the engine by
pulling the automatic take-up
chord (fig. 8).
5) Once the engine is running,
bring the starting lever (fig. 6B)
back to the original position.
!
Warning
- If there is not enough oil or
none at all, the engine does
not start.
- The high pressure water jet
generates a reaction force in
the lance. Keep a firm grip on
the lance handle.
Press the trigger on the gun
and begin washing.
!
Danger
- Do not block the handle lever
in the delivery position.
English
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfun-
ction (Fig. 9).
STOPPING THE CLEANER
1) After using with detergent,
flush out the intake circuit;
place the detergent suction
hose (fig. 10) in a tank of clean
water and let the pump run for
1 minute with the dosing tap
turned fully on and the lance in
detergent delivery condition.
2) Stop the cleaner.
a) Place the engine switch in
the OFF position. (fig. 7).
b) Place the petrol pump lever
in the closed OFF position
(fig. 6A).
FIG. 6
3) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun (fig. 5A).
4) Turn off the water supply
tap (fig. 4A).
!
Warning
- If the water cleaner is left,
even temporarily, turn it off.
- When the water cleaner is not
used, close the safety device
on the handle (fig. 11).
- Dry use of the water cleaner
causes serious damage to
FIG. 7
pump gaskets.
FIG. 8
- 21 -
FIG. 9
FIG. 10
FIG. 11