Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A D D I T I O N A L F I N E T U N I N G O F T H E P I V O T P L AT E
A D D I T I O N A L D E P T H A DJ U S T M E N T S
A D D I T I O N A L I N T E R N A L A N D E X T E R N A L R O TAT I O N L I M I T S
The standard setting of the Pivot Plate allows for 30° internal/30° external rotation from the neutral
position (aligned with the armrest of the chair). This provides the same function whether installed
on the right or left hand side.
Some users are capable of a greater range of internal arm rotation, which can be accommodated
by repositioning the Quick-Release Wedge on the bottom of the Pivot Plate to allow 45°
internal/15° external rotation.
S A F E T Y A N D P E R F O R M A N C E C H E C K S
User must be seated in wheelchair before performing safety check.
1 . N O R M A L O P E R AT I O N
Check for any pinch-points or loose parts.
2 . C O M F O R T
Look for areas of irritation.
3 . P O S I T I O N
Confirm correct position of user's upper
body and shoulders.
Additional adjustments can be made by repositioning the
Pivot Plate up to 25mm forward on the Base Board.
To access the mounting screws, remove the Quick-Release
Wedge and pull out the Pivot Plate Tab to unlock and
rotate it until the M6 mounting screws are visible through
the two access holes.
Loosen both screws to slide the Pivot Plate forward,
then fully re-tighten both screws and reattach the Quick-
Release Wedge.
3 0 ° / 3 0 °
4 . A D D I T I O N A L
Move the chair through full range of motion,
including tilt, folding, and rolling, and check
for any interference and adjust the Arm
Support if necessary.
1 5 ° / 4 5 °
Werbung
