Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTIONS
See page 3 for Connections.
@ CD player.
@ Adaptor component (graphic equalizer).
@ DAT/Tape decks.
@ Speaker system B (R).
® Speaker system B (L).
© Speaker system A (R).
@ Speaker system A (L).
Turntable.
© LD player, VCR etc..
@ Tuner
@ To an AC wall socket.
CONNECTING THE SPEAKER CORDS
1. Strip off the vinyl covering and twist the tip of
the wire core.
®
Twist the wire core.
2.
Loosen the knob and insert the wire core into
the terminal hole.
3. Tighten the knob to fix the wire core in place.
NO
>
Yy
NOTE:
Do not allow the wire core to protrude and touch other terminals or
wires. If the cores of differing wires touch, damage may be caused
to your amplifier and/or speaker systems.
Speaker Impedance
When speaker systems are connected to only the SPEAKERS A or
SPEAKERS 8
terminals,
such
speakers
should
have
rated
impedance in the range of
4-16Q.
When speakers are connected to both the A and B terminals, they
should have a rated impedance in the range of
8- 32Q.
CONNECTING THE INPUT/OUTPUT CORDS
Connect the white plug to the L (left) side, and the red plug to the R
(right) side. Be sure to push the plugs in securely.
Left channel
CO
The INPUT/OUTPUT jacks of this unit are dull tinplated, aiming at
high audio quality.
TO USE THE COMPONENT
CONNECTED
TO
THE ADAPTOR TERMINALS
1. Set the POWER switch to OFF.
2. Remove the two shorting bars from the
adaptor terminals.
White plug
Right channel
Shorting bars.
tT
NOTE:
Remove the shorting bars before connecting an equalizer to these
terminals. Always keep the bars inserted while the terminals are
not in use, and take care not to lose them.
7
<ARE1112>
E
Werbung
