Werbung
TROUBLESHOOTING ... -
~ ~ Symptom.
Remedy
Sk
© Power cord i is digSsnnected.
e instances are rare, but the problem may. | be due
i n of the protector circuit.
Power does not come on even
when POWER Switch is pressed '
. » Connect cord securely.
2 Static electricity affected the unit when the air
* was dry, Such as in winter.
: Control-was fot possible
"regardless of what operation
button was pressed:
© Unplg the power cord of the unit torn the AC
wall outlet, then plug it'in'again.
t
t icity | is pronounced, itis
ste the unit using
the. remote control unit. oe
* Consult:pages 14 — 24 and perform
connections Correctly:
* Press the MUTING button to Cancel the MUTING
effect.
* Raise volume.
No- sound is: produced, even
when the INPUT SELECTOR
button is selécted.
® Connections 'are incorrect.
* The MUTING button is pressed.
ee VOLUME i is turned down.
® Speaker connecting wires are disdonnectad from
Speaker terminals:
¢ Connect wires to terminals securely.
:
connections correctly.
:
® The VIDEO SIGNAL SELECTOR is not set properly. | * Set correctly.
No picture is produced, even
when the INPUT SELECTOR
button is selected,
« TV antenna is not connected to VCR, or
connections. are faulty.
| Tv source cz
can't be seen when
e eras the VCR's ; operating instructions, ar
the VCR's TV tuner is used.
:
ca
connect antenna correctly.
No rear sound is produced.
¢ The SURROUND
MODE switch is set incorrectly.
® The REAR LEVEL is turned down.
© Speaker connecting wires are disconnected from
_ REAR SPEAKERS terminals.
* Batteries are dead 'Or no batteries in remote
control-unit.
* Poor arglé'or too great a distance. fram 'the .
remote sensor window.
s There i is an Obstacle between you and the.
remote sensor window.
eA fluorescent light is shining on the remote
sensor windows...
¢ CONTROL MODE is not set for ie someone
you want to operate.
* You are pressifig a button that does. nat transmit
a signal.
:
* Set-correctly.
:
* Adjust the rear level with the remote control unit,
* Connect wires to terminals securely.
" aig of the remote sensor window.
| * Change: your position of move the obstacle.
* Move 0 fluorescent light does Not shine directly
on amplifier front panel remote sensor window.
* Select the correct CONTROL MODE button and
press:
« Refer once more to page 88, and press a button
_that facade a signal.
Abnormal functioning of this unitsmay be caused by lightning, static
electricity, or othér external intérference. To. restore normal operation,
turn the power off and then orf again, or unplug the AC power cord
and then plug. it in again.
90
< ARE1 248>
En
Werbung
