Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
deTAiLed peRFORMAnce dATA FOR The TML 100 LiFTing MAgneT
Values shown for load capacity of the TML 100 are based on material S235 JR for the maximum, vertical
tractive force with 0° deviation from the load axis and additionally under a 6° inclined load in accordance
with EN13155, in each case with a 3:1 safety factor. This manual does not contain any instructions for
use on round material, as the TML 100 is designed for flat material and round material or arched objects
may not be lifted.
Table 2
Thickness of material
mm
2
3
4
5
6
>6
Thickness of material
inches
0.08
0.12
0.16
0.20
0.25
>0.25
The maximum dimensions of the loads to be lifted depend to a large extent on the geometry and flexural
stiffness of the work pieces, since, in case of bending, an air gap forms under the magnetic surface and the
load-bearing capacity decreases significantly.During each lift, watch for any deformation of the work piece
that might occur and, if necessary, check for any air gap developing at the edges of the TiN-coated magnetic
surface (e.g. with a sheet of paper; 80g/m
Load capacity in kg
Clean, flat,
ground surface
Air gap <0.1 mm
0°
6°
30
27
50
45
80
72
95
85
100
90
100
90
Load capacity in lbs
Clean, flat,
ground surface
Air gap <0.004 inches
0°
6°
66
59
110
99
180
162
210
189
220
198
220
198
2
).
immediately stop the lift if there is any
!
excessive deformation or an air gap.
never exceed the dimensions and/or the load-bearing
!
capacity of the material thickness given intable 2.
Rusty,
slightly scratched surface
Air gap = 0.25 mm
0°
6°
25
22,5
40
36
60
54
70
63
70
63
70
63
Rusty,
slightly scratched surface
Air gap = 0.01 inches
0°
6°
55
49
90
81
130
117
155
139
155
139
155
139
Irregular,
rusty or rough surface
Air gap = 0.5 mm
0°
6°
22
19
35
31
45
40
50
45
50
45
50
45
Irregular,
rusty or rough surface
Air gap = 0.02 inches
0°
6°
50
45
75
67
100
90
110
99
110
99
110
99
21
Werbung
Inhaltsverzeichnis
