DeVilbiss Healthcare Drive TSE 120 Gebrauchsanweisung Seite 5

• Pull out the adjustable holders and set the desired
height. To do this, insert the rear support into the cor-
responding hole in the adjustable holder.
• Take care that the adjustable holers/supports on the
right and left are each connected at the same height.
Adjustable holders
Fixing screws
Rear support
• To adjust the height in the front, insert the front sup-
ports (A) into the corresponding openings until you
hear them click in place.
• Take care that the front supports on the right and left
are each inserted at the same height.
• The front supports can be set lower than the rear
supports.
The adjustable holders can only be inserted in one
direction into the raised toilet seat.
Drive Medical GmbH & Co. KG | As per: 05.04.2017 | Subject to error and change
8,5 cm
12 cm
15,5 cm
Knurled nuts
• Insert the two braces
(B) into the correspon-
ding openings until you
hear them click in place.
• Set the body of the
raised toilet seat back into
the rear support. In doing
so, the holders of the rear
support must engage with
the locking tabs.
Lid assembly
The lid is preassembled at the time of delivery, but can
be replaced if necessary. To do this, turn the body of
the raised toilet seat around and press the lid clips at
the same time. The lid can then be taken out of the hol-
ders. Clip the new lid on.
Safety Instructions
• The load on the raised toilet seat must not exceed
120 kg!
• The load on an individual armrest must not exceed
60 kg!
• The lid must not be used as a backrest in the opened
position!
• The lid must not bear a load when closed (by sitting
on it, for example)!
• Check the raised toilet seat regularly for a secure
fit on the toilet bowl. Retighten the knurled nuts if
necessary.
Maintenance and Care
The raised toilet seat should be regulary cleaned with
non abrasive cleaning materials.
Warranty
The warranty period for the raised toilet seat supplied
by us is 24 months.
Defective parts will be replaced free of charge if it
can be shown that there is a defect in materials or
manufacturing.
Damage caused by improper use is not covered by
the product liability.
Our products are subject to regular revision.
Reprocessing
The product is suitable for reprocessing in line with ma-
nufacturer's recommendations.
Disposal
At the end of the product's lifetime, the components of
the raised toilet seat should be disposed of properly.
The parts are all recyclable and can be disposed of in
the domestic refuse.
User Manual Raised Toilet Seat TSE 120
EN
5