Set The Basic Settings - JVC KD-R889BT Bedienungsanleitung

GETTING STARTED
3

Set the basic settings

1 Press and hold .
2 KD-R981BT/KD-R784BT/KD-R782BT: Turn the volume knob to select an
KD-R889BT/KD-R881BT:
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
SYSTEM
KEY BEEP (Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
AM SRC *
ON: Enables AM in source selection. ; OFF: Disables. ( 6)
BUILT-IN AUX * ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RESET YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
* Not displayed when the corresponding source is selected.
item (see the following table), then
press the knob.
Press to select an item
(see the following table), then press
.
.
Default: XX
CLOCK
TIME SYNC ON: The clock time is automatically set using the Clock Time (CT) data in
FM Radio Data System signal. ; OFF: Cancels.
CLOCK DISPLAY ON: The clock time is shown on the display even when the unit is turned
off. ; OFF: Cancels.
ENGLISH
Select the display language for menu and music information if applicable.
РУССКИЙ
By default, ENGLISH is selected.
ESPANOL
5
ENGLISH