Setting The First Remote Control - cherubini DOMOTIC TX Bedienungsanleitung

The domotic transmitter is factory set to operate in standard mode.
The mode can be changed from standard to advanced mode and vice versa with the
following command sequence:
- Disconnect the power supply, wait 2 seconds.
- Hold the SET button down and power up.
- Release the set button as soon as the LED blinks (around 2 sec).
When the Domotic TX comes on it indicates the mode set:
- One LED blink: standard mode
- Two LED blinks: advanced mode.

SETTING THE FIRST REMOTE CONTROL

This operation can only be performed when the motor is new, or after a total delete of
the memory.
During this step, power up only one motor at time!
T1: First remote control to be set
+
A B
T1
To associate the transmitter to a motor, a remote control must be already memorised on
the motor. The setting sequence is the following:
Tn: Already programmed remote control
+
A B
Tn
MODE CHANGING
LED
2 sec
SETTING THE DOMOTIC TRANSMITTER
SET
B
T1
B
Tn
12
3
LED
SET
2 sec
B
T1 (2 sec)
SET
(2 sec)