Hitachi CSNET MANAGER XT Installations- Und Betriebshandbuch Seite 26

Local software configuration
2.4 USB MEMORY CONNECTION
1 Plug in the USB memory in the USB port of the CSNET Manager.
2 Program starts up automatically.
3 Please wait until a window pops up.
4 This windows allows browsing the contents of the USB memory (instruction manuals in PDF files, system recovery, etc.).
2.5 START UP PROCESS
1 Connect the power cable.
2 Connect the LAN1 cable.
3 Switch ON the CSNET Manager.
4 Wait until the screen is started and CSNET Manager software is launched automatically.
3 LOCAL SOFTWARE CONFIGURATION
After configuring the CSNET Manager interface you should begin the configuration of the system. To install the RCS Web instead
of CSNET Manager read the chapter
remote control functions but more user-friendly for a non-expert user.
?
N O T E
CSNET Manager needs at least the following to be configured:
• Local software configuration (see next page)
• Area tree (see chapter "4.1 Area
• Configuration of the unit (see chapter
• Auto Cool/Heat (see chapter
• Fan stop heating during thermo-off (see chapter
We recommend configuring the other points indicated in the manual at the same time, although this can be done later.
After switch ON the CSNET Manager, a page appears in which must be specified the language you want to use. The same screen
shows a timer (this can be configured later), which runs down to zero and then runs the software in the selected language.
Wait 10 seconds or press the OK button, CSNET Manager will show the Initial Page.
?
N O T E
Please be aware that pressing the ON/OFF button of CSNET Manager forces a complete shut down
20 PMML0303A rev.2 - 02/2015
Web". Remember that RCS Web is a reduced version of CSNET Manager with only
"8 RCS
tree")
"7.6 Unit Setting")
"4.6.7 Auto cool/heat")
"4.6.8 Fan stop heating during thermo-off")