Programming - GOK SmartBox 4 GSM Montage- Und Bedienungsanleitung

PROGRAMMING

Operating media may leak. These:
• are hazardous to water,
• are category 1,2 and 3 inflammable liquids,
• can ignite and cause burning,
• may cause falling injuries due to slipping.
Enter these values with care!
The entry values are also retained in the event of the failure of the supply voltage.
Programming the level gauge
Before programming, you need to ascertain the tank data and enter the values into the right
column (Input value) of the following table. Then, enter the values for the individual entry
steps.
Setting a
parameter:
Quitting the
setup mode:
Menu
Tank: 1
 SmartBox 4
PRO
0.Exit
1.Probe
Part no. 28 400 57 e
Overfilling of the tank due to incorrect entry values.
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
You can quit the setup mode at any time.
Select "Exit" and press [ENTER]
 to go back to the standard display mode.
Input function
Select the tank (tank: 1 to tank: 4) to enter the
corresponding values. (This step is not displayed if
only one probe is connected to SmartBox 4 PRO.)
Press [ENTER] to return to display mode
Select probe measuring range see type label of the
probe - default setting 250 mbar
Standard probe
100mbar
150mbar
160mbar
200mbar
250mbar
400mbar
500mbar
1.000mbar
2.000mbar
3.000mbar
5.000mbar
Set mbar
max. tank height for
fuel oil
1.20 m
1.80 m
1.90 m
2.40 m
2.90 m
4.70 m
6.00 m
12.00 m 10.00 m
24.00 m 20.00 m
36.00 m 30.00 m
60.00 m 50.00 m
Input value
Tank:_______
_
water
1.00 m
1.50 m
1.60 m
2.00 m
________mbar
2.50 m
4.00 m
5.00 m
11 / 28