BSL -S70 Bedienungsanleitung Seite 20

instructions
TWS function
This feature allows you to wirelessly connect two BSL-S70 speakers to the same source at
the same time. The procedure is as follows:
1) Take the 2 BSL-S70 speakers, we will call them A and B, take speaker A and connect it
via Bluetooth with the smartphone, then we take speaker B and select it
Bluetooth function, press the button
It switches to TWS function and then automatically connects to Speaker B.
You will hear a "tick" sound on Unit B if the connection is successful.
2) After a successful connection, the BLUE text remains static and stops flashing. flashes, then
start listening to music through both speakers, one as the right channel and the other as the left
Channel acts. To exit TWS mode, press the TWS button again.
Remote control function:
the unit A e
PLAY
1. Power on/off.
2. When pausing or playing MP3/auto searching for FM
stations.
3. Decrease the volume.
4. Sound equalizer mode.
5. Repeat what was played.
6. Select the song from 0 to 9
7. AUX/USB/TF/FM/BT input selection
8. Mute.
9. In the last MP3 song / in the last FM station
10. Go to next MP3 track/FM station.
11. Increase the volume.
12. Select USB/TF.
Solving big problems
If you have problems using the speakerphone, try the following steps
Troubleshooting. If you cannot find a solution to your problems, contact technical support. Please
For your own safety, do not attempt to repair the device yourself.
possible problem
Symptoms
1. Low battery
It doesn't work
Without light
2. The power switch of the device
is switched off
Without sound
1.Cable disconnected
easy though
Not
2. Speakers not connected
Sounds
3.No audio signal
to the speakers
If the problem persists after checking the above procedures, contact the
appropriate service representative or professional technician for troubleshooting.
Do not attempt to open the lid, otherwise we will not be held liable.
Manual Multilenguaje / Manuel Multilingue / Manual Multilingual / multilingual manual
Solution
charge the battery
Turn on the button
Shut down your computer and make sure
all
Audio connections are tight.
Turn it off and check again if the
cable is secure
connected.
Make sure you send the audio signal from the
selected source to the speakers