Axis OfficeBasic USB Wireless G Installationsanleitung Seite 8

Hardware Installation
1. Turn off the printer's power.
2. Connect the print server to your printer with the supplied USB
cable.
3. Turn the printer's power on.
4. Plug the AC power adapter into the power connector on the
side of the wireless print server.
5. Wait 1 minute until all the LEDs have stopped flashing (the
WLAN LED will continue to flash if data is being transmitted).
6. Press the print server's external Reset button for 5 seconds. A
test page will be printed on the connected printer, displaying
information about the print server's IP address, firmware
number, etc.
Power connector
DIP switch:
NOR = Normal mode
DIAG = Diagnostic Mode
Continue with Setup in Infrastructure Mode, on page 9 or Printer
Installation - Mac OS X, on page 21.
Reset button:
- Press once to restart print server.
- Press 5 seconds to print test page.
8
USB Connector
USB LED
WLAN LED
Power LED