Braun BC08-DCF Kurzanleitung Seite 2

BC08-DCF
Travel alarm clock
(Radio controlled)
Quick set-up guide
For detailed information refer to
the full user manual available at
www.braun-clocks.com/pages/warranty
or scan this code:
Braun helpline
Should you have a problem with your
product, please check your local service
centre at:
www.braun-clocks.com
www.braun-watches.com
Certain trademarks used under license from the
Procter & Gamble Company or its affiliates.
2
1
6
Battery installation
1. Remove the battery door.
2. Insert 1x AAA size new battery as indicated in the
battery compartment ( 1 ) and press the RESET key ( )
to reset the clock. The display will turn on after a few
seconds.
3
3. Close the battery door.
Only use new alkaline batteries from a reputable
4 brand.
Radio controlled clock operation
We strongly recommend you start your clock at night.
Once the battery is installed properly, the clock begins
5
receiving the DCF signal. Once it has received the signal
and processed it accordingly (which takes 3 to maximum
12 minutes), the clock will automatically display the
correct time.
Setting the time
1. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch ( ) to the TIME SETTING position.
2. Press the '+' or '-' key (
3. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch to the NEUTRAL position to return
the normal display and save the settings.
Setting the alarm
1. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch ( ) to the ALARM SETTING position.
2. Press the '+' or '-' key (
3. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch to the NEUTRAL position to return
the normal display and save the settings.
Using the alarm function
1. Enable the alarm by pushing the ALARM ON / OFF
slider (
2. To disable the alarm and snooze function, push the
ALARM ON / OFF slider down.
Using the snooze function
Tap the SNOOZE touch button ( ) to stop the alarm
and activate the snooze function. When the snooze
function is activated, the alarm will automatically
start again after 5 minutes. The snooze function will
not stop unless the ALARM ON / OFF SLIDER is
pushed down
2
2
) to set the desired value.
4
2
) to set the desired value.
4
) up (so the green indicator is visible).
3
6
5