BREW MONK B40 Handbuch Seite 19

EN – Brew Monk User Manual
1. Safety instructions
• Read all the instructions carefully and keep this manual for future reference.
• Do not use the appliance if the cord or plug is damaged; these must be replaced before use.
• The machine is intended for use only with 220-240 V and 50/60 Hz. Do not use an adaptor as the
wattage power of this appliance is high.
• Avoid overloading the electric supply.
• If the appliance requires extra power, do not use multi-sockets of under 13 A, and do not connect any
other device to the socket.
• Check the product's rating label and make sure its voltage is fit for your power socket before use.
• The appliance must only be used as intended. It must be operated safely and correctly under fault-free
conditions. Make sure you check the product's condition prior to each use.
• The appliance is only to be installed in locations where it is supervised.
2. Preparations before brewing
• The appliance must be positioned on a stable, secure and horizontal support structure prior to use.
• A full vessel contains boiling hot liquids and can weigh up to 40 kg (B40), 50 kg (B50) and 70 kg (B70).
Horizontal positioning is a prerequisite for transfer pumping during the brewing process. Avoid an
unsteady surface.
• Do not move the appliance during the brewing process. The handles are only meant for transporting the
appliance in an empty state.
• It is imperative to keep children and animals away from the appliance while it is in use. Remember
boiling water is very dangerous.
• Always clean all the parts of your brewing equipment. Hygiene is imperative for good brewing results.
• Before use, it is advisable to heat a quantity of hot water in the kettle to clean the brewing equipment by
using a proper cleaning agent (Chemipro
2.1 Assembling the circulation pipe and information about the pump
• Important: Never run your pump without water! The kettle must be filled with water before switching on
the pump. If this is not the case, the pump may be damaged.
• We recommend using the pump during the mashing process.
• Before switching on the pump, make sure to install the curved pipe (11). Assemble the curved pipe
(11) by placing it on top of the circulation pipe (2). Check that the seal ring is installed and lock the
curved pipe (11) in place by pressing down the two handles. If you want to use the glass lid (5) during
mashing, you will have to install the lid (5) before assembling the curved pipe (11). The curved pipe
(11) should first be inserted through the hole in the lid (5).
19
Wash).
®