Alecto DVM-360 Bedienungsanleitung Seite 48

Night light:
1. Press and hold the button
2. Repeatedly press the button
ON or OFF.
3. Press the button
4. Shortly press the button
Brightness:
1. Press and hold the button
2. The symbol
3. Press the button
high intensity (
4. Shortly press the button
Don't forget that a high intensity uses more power. When using the parent unit
with the built-in battery, please select a low intensity to prolong the battery's life
span.
Temperature indication and warning:
The temperature of the room with the baby unit is shown above in the display of
the parent unit. You can select to show the temperature in degrees Fahrenheit or
in degrees Celsius. Besides that, you can let the unit sound an alarm tone when
the temperature in the baby room becomes too high or too low.
1. Press and hold the button
2. Repeatedly press the button
or °F.
3. Press the button
4. Shortly press the button
value for the temperature alarm.
5. Use the button
prefer not to set a lower limit).
6. Shortly press the button
value for the temperature alarm.
7. Use the button
prefer not to set a lower limit).
8. Shortly press the button
As soon as the temperature becomes too low or too high, the unit will now sound
short alarm tones while the temperature display will start flashing on the display.
Don't forget that the temperature is only an indication and you must take into
account a possible deviation of + or - 2 degrees.
48
to open the menu, now release this button.
until
or to switch the night light on (' ON') or off (' OFF').
to save the setting and to close the menu.
to open the menu, now release this button.
will on the display, followed by the current setting.
or to set the brightness from low intensity (
).
to save the setting and to close the menu.
to open the menu, now release this button.
until ' ' appears on the display, followed by °C
or to switch between °C and °F.
, 'Lo' will appear followed by the lower threshold
or to set the lower threshold value (or select OFF if you
, 'Hi' will appear followed by the upper threshold
or to set the upper threshold value (or select OFF if you
to save the setting and to close the menu.
' ' appears on the display, followed by
) to