Sophos SG 750 Bedienungsanleitung

Sliding Rails Mounting Instructions
The rails fit into EIA racks with 5/8" pitch and square holes. Please replace the screws assembled on the
front bracket of the rails with the supplied smaller screws for mounting them into round-hole racks.
Step 1: Remove the Inner Rails
Pull the slide open. Then push the white trigger
forward as shown on the drawing, and pull the
inner rails out.
Pull inner
member out
Step 2: Attach the Inner Rails to the Chassis
Mount the inner rails on each side of the appliance
by using the provided screws.
United Kingdom and Worldwide Sales
Tel.: +44 (0)8447 671131
Email: sales@sophos.com
Oxford, UK | Boston, USA © Copyright 2015. Sophos Ltd. All rights reserved.
Registered in England and Wales No. 2096520, The Pentagon, Abingdon Science Park, Abingdon, OX14 3YP, UK.
Sophos is the registered trademark of Sophos Ltd. All other product and company names mentioned are
trademarks or registered trademarks of their respective owners.
Press trigger
forward to
release
North American Sales
Toll Free: 1-866-866-2802
Email: nasales@sophos.com
SG/XG 750
Step 3: : Attach the Outer Rails to the Rack
Insert the front and rear of the outer rails into the
rack until it clicks. Make sure that the latches are
locked so that the rails can't be released.
Unlock the latches for dismounting the rails.
Click 1
Step 4: Mount the Appliance into the Rack
Note: It's strongly recommended to carry out this
procedure with two or three persons.
Insert the appliance into the cabinet member as
shown below. While you are pushing the chassis
back to the cabinet, you need to release the slide
from locking position by pushing the blue trigger
forward.
Push
Australia and New Zealand Sales
Tel.: +61 2 9409 9100
Email: sales@sophos.com.au
Click 2
Asia Sales
Tel.: +65 62244168
Email: salesasia@sophos.com
2015-08-24 NA (DD-2193)