BSS ATEM Mini Bedienungsanleitung Seite 23

Installing the ATEM Mini / Extreme
Safety note: Before doing any work on the BSS case, pull the mains plug out of the
socket!
Do not touch the built-in electronic components when the installation slot is open.
Even when the mains plug is unplugged, these can remain live for a long time and
cause an electric shock.
Risk of tipping: When installing the
ATEM Mini Extreme yourself, there is
an acute risk of tipping over after
opening the lid in its end position.
Only after installing the ATEM Mini
does the case reach the balanced
center of gravity.
Therefore, when opening the cover,
hold the case in a horizontal position
with the help of a second person un-
til the ATEM Mini Extreme has been
installed.
Plug in the cables
(Image 11) Danger of tipping over
if ATEM Extreme is not installed
(Image 12) Plug the cable into the ATEM
Note: Never pull the cables with force,
as this could damage them.
Note: Work carefully and never force the ATEM Mini into the recess! If you feel too
much back pressure or if the cover plate deforms under the pressure of the cables,
carefully remove the ATEM Mini / Extreme and sort the cables again until the ATEM
Mini / Extreme can be inserted into the recess without too much counter pressure.
You may have to repeat this process several times until the ATEM finds its pressure-
free seat.
With the ATEM Extreme, the
counter-pressure when used is
correspondingly higher due to
the almost double number of ca-
bles. However, please also note
the above-mentioned conditions
for assembly.
(Image 13) Swing in the ATEM Mini
(Image 14) Screw ATEM Mini with C-clamps
DE
EN
FR
IT
ES