HBM T40FM Montageanleitung Seite 31

T40FM
Important
Keep them in a safe place for future dismounting.
5. There are relevant tapped holes on flange B for con­
tinuing the shaft train mounting. Again use screws of
property class 10.9 and tighten them with the pre­
scribed torque, as specified in Tab. 5.1, Page 30.
Important
Use a threadlocker (medium strength, e.g. LOCTITE) to
glue the screws into the counter thread to exclude
prestressing loss due to screw slackening, in the event of
alternating loads.
Notice
Comply with the maximum screw-in depth as per
Tab. 5.1, Page 30. Otherwise significant measurement
errors may result from torque shunt, or the transducer
may be damaged.
A3276-8.0 HBM: public
Mechanical installation
29