Comprag RDX Serie Bedienungsanleitung Seite 21

4.4 Set advanced parameters
Установка дополнительных параметров.
With the controller you can control the compressor and the dryer fan as well as calibrate
the operating parameters. In case of special operational control requirements, the user can
change the values of the programmed parameters. Press and hold the button
seconds. Enter password.
Designation Description
PS Password
/2 Measurement
/3 Number of hours for Ecd
/4 Selection of the displayed sensor
/5 Choice 0=˚C and 1=˚F
/6 Disable decimal point
/С1 Sensor calibration 1
/С2 Sensor calibration 2
Stl Setting the minimum dew point (ECO
mode)
StH Setting the maximum dew point (ECO
mode)
L1 Low dew point alarm threshold with
compressor off
L2 Low dew point alarm threshold with
compressor on
r5 Lower display limit (sensor1)
r6 Upper display limit (sensor1)
tE Operating time in ECO mode
tE1 Minimum ECO operating time
tL Time delay for low dew point alarm
С0 Compressor and fan start delay
COMPRAG RDX series compressed air refrigerated dryer
ATTENTION! Contact your local dealer for a password to change
system parameters. It is forbidden to change the factory settings
without any apparent reason!
Range Unit
measurements
1-200 ___
1-15 ___
1-24 ___
1-3 ___
0;1 ___
0;1 ___
+-12,7 ˚С
+-12,7 ˚С
-2;100 ˚С
0-100 ˚С
-50;200 ˚С
-50;200 ˚С
-2; r6 ˚С
r5;200 ˚С
1-199 sec
1-199 min
0-90 sec
0-200 min
within 3
Chief
settings
22
4
8
1
0
0
0
0
0
15
2
-2
3
7
60
6
65
1
21