IKIER K1 Pro MAX Benutzerhandbuch Seite 51

03
04
02
( B ) How to set "Auxiliary positioning" function in LaserGRBL:
01. In the following toolbar, right click on the blank space to pop up the
"Add Custom Button" window, click "Add Custom Button"
02. Enter [ESP501] in "GCode", enter the button name in "Caption" and
"Tool Tip", you can customize the button picture on the left, and click
"Create" to generate a custom button with the corresponding function
01
04
02
03
05
SETTING PART
( B.1 )How to use "Auxiliary positioning" function in LaserGRBL:
01. Click "Set Origin"
02. Click "Frame"
03. Click "Auxiliary Positioning"
04. Click "Start"
01 02
04
Sinking Cutting
01. Open LightBurn, click "Device Settings", and enable Z-axis.
02. Set the number of passes and the Z-axis step size of each pass, and click OK.
* WARNING:
01. The fixed focus distance of the laser module is 8mm, so "Number
of Passes*Z step per pass<8mm", so as not to touch the lower limit
switch and trigger alarm.
02. The focus must be fixed according to the standard 8mm height,
and the focal length of the laser head cannot be lowered at the
beginning, otherwise the flame detection function will be
triggered by mistake.
03
- 47 -