EN
User manual
1
Introduction
This set is a good equipment for photography. All the parts are
standard so you can use it with your camera to get accurate
photos the way you want. It is packaged safety and tracked
during transit so you don't have to worry about damage or
misdelivery.
2 Warnings and personal safety
See image 1
•
This designation means that this product must not be
disposed of with other household waste in the European
Union. Please be aware that VidaXL is making a return and
collection system available to you for discarding these
products. This possibility is free of cost. When you recycle
WEEE or batteries/accumulators you are helping to prevent
that the products are not incinerated or sent to landfills.
Therefore, you are helping to minimize the potential
negative impact on human health and the environment.
Responsible recycling can increase the reuse of material
resources and avoid potential damage to the environment
or health from uncontrolled waste disposal.
To prevent damaging your product or injuring yourself or
others, read the following safety precautions completely before
using this equipment. Keep these safety instructions where all
those who use this equipment can read them.
•
The luminaire can under no circumstances be mounted on
normally flammable surfaces.
•
For indoor use only.
•
If the external flexible cable or cord of this luminaire is
damaged, it should be exclusively replaced by the
manufacturer, its service agent, or a qualified person in
order to avoid a hazard.
•
Isolate electrically before re-lamping. CAUTION – Hot lamp.
•
Minimum distance from flammable material to the exterior
surfaces of the luminaire is 10 mm.
•
The value of the exterior surface (lampholder) temperature
when in a steady state is 50 °C.
•
Shields, lenses, or ultraviolet screens should be replaced if
they have become visibly damaged to such an extent that
their effectiveness is impaired, for example by cracks or
deep scratches.
•
The lamp should be replaced if it has become damaged or
thermally deformed.
6 Do not disassemble or modify.
Failure to observe this precaution could result in electric shock
6 | 190274+190238+190208+190260
or product malfunction. Should the product break open as a
result of a fall or other accidents, please send the defective item
to a professional technician for maintenance.
6 Keep dry.
Do not handle with wet hands, immerse in water, or expose to
rain. Failure to observe this precaution could result in fire or
electric shock.
6 Do not use in the presence of flammable gas.
Failure to observe this precaution could result in explosion or
fire.
6 Keep out of reach of children.
This device contains small parts which may pose a choking
hazard. Consult a physician immediately if a child swallows any
part of this device.
6 Do not expose to high temperatures.
Do not leave the device in a closed vehicle under the sun or in
other areas subject to extremely high temperature. Failure to
observe this precaution could result in fire or in damage to the
casing or internal parts.
5 We are constantly upgrading the program of our softbox
to meet the new demand in the market. As such, some of the
new changes made to the specifications may not be updated
in this manual.
3 Assembly instructions
3.1
Bracket installation
See image 2
1. Release the clip of tripod leg.
2. Unfold the tripod leg.
3. Open the clip on tripod.
4. Take off the tripod plastic cap.
5. Connect the bar.
6. Bar assembly finished.
7. Assemble the bar on the tripod.
8. Finished.
3.2
Lamp 1 installation
See image 3
3.3
Lamp 2 installation
See image 4
4 Technical specifications
Electrical parameters
Lamp