Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Accessories
This device includes different accessories that allow cleaning different types of surfaces,
objects, and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jaliscazo brush
Assemble this brush to the upright vacuum cleaner. This brush is especially designed for
cleaning hard floors, but can be used to efficiently clean soft floors too.
2-in-1 narrow accessory for corners and furniture
Fig. 4
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
2-in-1 wide accessory for corners and furniture
Fig. 5
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
Long brush
Fig. 6-7
Suitable for cleaning surfaces which are sensible to scratches such as furniture, wardrobes,
etc.
Motorised brush for upholstery
Fig. 8
This accessory is used with the handheld vacuum cleaner for an intense cleaning of upholstered
furniture.
Special brush for fabrics
Adjustable accessory to remove all types of dust trapped in fabrics.
Flexible vacuuming tube
Use the Flex tube to reach and vacuum dirt from the most inaccessible areas. Press the Flex
button to bend the tube.
Extensible tube
Use the accessory with the handheld vacuum cleaner to reach and vacuum dirt from the most
inaccessible areas. Moreover, you can connect the 2-in-1 narrow and wide accessories for
furniture and corners and the extension brush.
48
Union elbow
Fig. 9
Suitable for dusting high cupboards, roofs, windows, corners, etc. Moreover, you can connect
the 2-in-1 narrow and wide accessories for furniture and corners and the extension brush.
Watertank accessory
With this accessory you will mop and scrub your floor just by attaching it to the vacuum cleaner.
Wall charging base installation
Fig. 10
1.
Place the charging base on the wall and mark 3 spots to be drilled to fix the base. You
must take into account the height of the installation; it is important that vacuuming brush
head rests on the floor to avoid the charging base from holding all the vacuum cleaner's
weight.
2.
Drill the 3 holes (previously marked) and insert the pegs and M4 x 32 mm screws.
3.
Make sure that the charging base is securely fixed on the wall and place the vacuum
cleaner on the charging base by placing the vacuum cleaner's charging terminals over the
charging base's charging terminals (plastic tab).
4.
Once the wall charging base is installed, connect the power adapter to the charging port,
and then you can charge the vacuum cleaner by simply sliding it up and down the wall
charging base. Fig. 11
Charge and display
-
When the battery percentage is 20% or below, the device will automatically enter low
consumption mode. It is recommended to charge the vacuum cleaner when it reaches this
percentage.
-
The battery must be charged with the charging base while it is connected to the main body.
Connect one of the ends of the power adapter to the power supply and the other to the
charging base. Fig. 11
-
During charging, the charge light indicator will turn on red and the display will show the
current charge percentage. When the device is fully charged, the battery indicator will turn
green, and the display will show 100 %. Fig. 12
-
You can also charge the battery without using the charging base. You can charge the
battery when the battery is installed or not in the vacuum cleaner. Connect the adapter and
connect the other end to the battery, paying attention to the direction. Once it is properly
connected, the charge light indicator will turn on red and will turn green once the charge
is complete. Fig. 13
ENGLISH
CONGA ROCKSTAR 9500 CONNECTED ERGOWET 3000 IA
49
Werbung
