What To Do If - IKEA RENLIG FWM7 Bedienungsanleitung

ENGLISH
1
2
• Unscrew the hose from the appliance.
Keep a rag nearby because some water
may flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
3
35° 45°

What to do if...

The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a
stiff brush.
• Screw firmly the
inlet hose back
onto the tap.
• Screw the hose
back to the appli-
ance turning it to
the left or the right
to suit the installa-
tion. Tight the
locknut correctly
to prevent water
leaks.
• Turn on the water
tap.
The dangers of freezing
If the appliance is exposed to temperatures
below 0°C, certain precautions should be
taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain out.
• Screw the water inlet hose back on and re-
position the emergency emptying hose af-
ter having put the cap on again.
• When you intend to start the appliance up
again, make sure that the room tempera-
ture is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as fol-
lows to empty out the appliance:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has
cooled down;
• open the pump door;
• place a bowl on the floor and place the
end of the emergency emptying hose into
the bowl. Remove its cap. The water
should drain by gravity into the bowl.
When the bowl is full, put the cap back on
the hose. Empty the bowl. Repeat the pro-
cedure until water stops flowing out;
• clean the pump if necessary as previously
described;
• replace the emergency emptying hose in
its seat after having plugged it;
• screw the pump cover again and close the
door.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with wa-
ter.
•
- The appliance does not drain the
water.
•
- The appliance door is open or not
closed correctly.
20