Z Alarm Volume; Z Standby Function; Z Optical Interface; Z Default Language - Schulthess Spirit eMotion TW 7235i Bedienungsanleitung

Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The level can be adjusted in 3 levels.
Off
Level 1
Level 2
Level 3
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. The display will show «ZZZ».
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory DEUTSCH)
Select «Extended basic settings»!
If another language is temporarily selected via the
buttons and
mode or after a long standstill, the setting reverts back
to the default language.
Delete myTop5
Select «Extended basic settings»!
When calling this function, it is always set to «OFF».
To delete the favourite programmes saved in «myTop5»,
this function must be set to «ON» and the basic setting
must be quit using the fast forward button
This will delete the programmes saved in «myTop5», the
basic setting is set to «OFF» again and resaves your
«myTop5» favourite programmes.
Start time preselection (ex factory 24 HOURS)
Select «Extended basic settings»!
The maximum adjustable range of the start time delay
can be reset from 24 hours to 100 hours.
, after programme end, in standby
.
61
Problems

Error messages

If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectified.
«CHILD LoCK ACTIVE»
X Hold the start button down and press the fast
forward button (see chapter «Basic settings»).
«PLEASE CLoSE DooR»
X Push door closed until lock engages.
«CoND. WATER FULL»
X Empty the condensed water container (see chapter
«Starting the programme»).
X Fluff filter in the condensed water container is dirty.
Clean the filter according to the instructions. (see chap-
ter «Cleaning and Care»)
If the machine displays an F - - error message:
X Interrupt the programme using the fast forward button
and select a new programme.
If error messages appear repeatedly:
X Switch off the power for around 1 minute and switch
it back on again (pull out the plug or switch off at the
wall).
 The machine is ready for use again when the pro-
gramme control lights flash.
X Select a new programme.
If an error message appears again:
X Make a note of the error message.
X Unplug the machine or switch it off at the wall.
X Notify customer services.

Troubleshooting

Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.
Rectifying minor faults yourself
The machine does not start after pressing a
programme button:
X Check whether the mains power is switched on at the
wall and the plug is in.
X Check whether all the fuses are intact or the safety
switch has tripped.
The display is dark:
X The machine is in standby mode. No error. To operate
the machine press any button.
The machine does not start:
X The start button has not been pressed.
X Start time preselect has been set. Only starts at the
preselected start time.