Stiga 95 Combi EL QF Gebrauchsanweisung Seite 99

9. STORING
When you intend to put your machine
away for more than 30 days:
1. Clean the accessory thoroughly.
2. Check the accessory for any damage.
If necessary, carry out any repairs.
3. If the paint is damaged, touch-up
the areas to prevent rusting.
4. Protect all metal surfaces exposed to rust.
5. Store the accessory in a closed
environment if possible.
6. We highly recommend storing the machine
with the cutting-means assembly in the
working or transport position, to prevent
damage to the transmission belt (Please
also read the instructions provided in the
ride-on mower with front deck manual).
10. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardize
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
• Genuine spare parts are supplied by
authorised assistance workshops and dealers.
13. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
All manuals and user guides at all-guides.com
• It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance
and safety device inspection.
11. HANDLING AND TRANSPORTATION
When handling or transporting
the machine, always:
• Stop the machine
• Wait for the cutting means to come to a halt
• Bring it to the minimum cutting height (par. 5.1).
• Release the cutting-means assembly from
the ride-on mower with front deck (chap. 4.3)
• Allow it to move on the wheels (fig. 1.D).
12. WARRANTY COVERAGE
The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, headlights, wheels,
blades, safety bolts and wires.
• Normal wear and tear.
• Engines. Engines are covered by
the warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
First time And then
after every
- Before each use
EN - 9
Paragraph
7.3