Safety Precautions; Warning; Caution - INVENTOR C2-10L Bedienungsanleitung

SAFETY PRECAUTIONS

Please comply with the following instructions to avoid injury or property damages. Incorrect operation
or non compliance of these instructions may cause harm or damage.
The following indicators classify the seriousness of safety.

WARNING

CAUTION

Meanings of symbols used in this manual are as shown below.
Do not exceed the rating
of the power outlet or
connection device.
May cause electric shock or fire
due to excess heat generation.
Do not modify the power cord
length or share the outlet
with other appliances.
May cause electric shock or fire
due to excess heat generation.
Disconnect the power if
strange sounds, smell, or
smoke occur.
May cause fire or electric
shock.
Do not use the unit near
flammable gas or combustibles, such
as gasoline, benzene, thinner, etc.
May cause an explosion or fire.
Do not use the unit in small
spaces.
Lack of ventilation may cause
overheating and fire.
This symbol indicates the possibility of death or serious injury.
This symbol indicates the possibility of injury or property damage.
Never do this.
Always do this.
WARNING
Do not operate or stop the
unit by switching the power
supply on or off.
May cause electric shock or fire
due to excess heat generation.
Do not insert or pull out
the plug with wet hands.
May cause electric shock.
You should never try to take
apart or repair the unit alone.
May cause unit failure or electric
shock.
Do not drink or use the
collected water from the unit.
Contains contaminants and
could make you sick.
CAUTION
Do not place the unit where
water may splash on it.
Water may enter the unit and degrade
the insulation. May cause an electric
shock or fire.
2
Do not use a damaged or
non compliant power cord.
May cause electric shock or fire.
Do not place the unit near
a heat source.
May cause melting of parts or fire.
Before cleaning, turn off
the power and unplug the
unit.
May cause electrical shock or
injury.
Do not remove the water
bucket during operation.
May cause electric shock.
Place the unit on a
level, sturdy section
of the floor.
If the unit falls over, it may
cause water spillage,
property damage,
electric shock or fire.