Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Commissioning/operation
B5
Direction buttons:
You can press any of the movement buttons singly or
together. The arrows on the buttons show the respec-
tive direction of movement.
Driving forwards
All drive units pull forwards with full
power.
Turn towards the right front*
Only the left drive units pull forwards
with full power. Only the right drive
units are blocked.
Turn towards the left front*
Only the left drive units pull forwards
with full power. Only the left drive units
are blocked.
Turn towards the right rear*
Only the left drive units pull backwards
with full power. Only the right drive
units are blocked.
Turn towards the left rear*
Only the right drive units pull back-
wards with full power. Only the left
drive units are blocked.
* The inner wheels are blocked during this rotational
movement. This may cause the wheels to dig into soft
ground. Use this movement only when the ground is
sufficiently firm.
Driving backwards
All drive units pull backwards with full
power.
Arc towards the front right
The left drive units pull forwards with
full power. The right drive units pull
forwards with reduced power.
Arc towards the front left
The right drive units pull forwards with
full power. The left drive units pull
forwards with reduced power.
Arc towards the rear right
The left drive units pull backwards with
full power. The right drive units pull
backwards with reduced power.
Arc towards the rear left
The right drive units pull backwards
with full power. The left drive units pull
backwards with reduced power.
"TANGO"-type right turn
The easydriver automatically manoeu-
vres along a curve (see Figure). The
electronic
switches the direction of rotation.
"TANGO"-type left turn
The easydriver automatically manoeu-
vres along a curve (see Figure). The
electronic
switches the direction of rotation.
"TANGO"-type right turn
Buttons for automatic engaging /
disengaging. Both buttons have to be
pressed at the same time. During
engaging or disengaging the related
symbol is flashing. The system will recognize the end
position of the system and indicate this by a permanent
enlightened symbol.
If either the engaging or disengaging operation is inter-
rupted or the end position of the system will not be
recognized an acoustic alarm will be heard ( 3 beeps)
and the related symbol will flash.
In this case you have to check to correct posi-
tion of the drive units!
system
automatically
system
automatically
"TANGO"-type left turn
GB9
Werbung
Inhaltsverzeichnis
