SunPower SPR-MAX6-435-AC Bedienungsanleitung Seite 13

SunPower Performance 6 Residen al AC Solar Panel
(SPR-P6-XXX-BLK-E8-AC, SPR-P6-XXX-BLK-E9-AC)
50
90 mm
235 mm
TOP CLAMPS
Moun ng
Moun ng Configura on Diagram
Configura on
Descrip on
Front View Back View
Long Side Moun ng,
Rails Perpedincular
to Moun ng Frame
Long Side Moun ng,
Rails Perpedincular
to Moun ng Frame
Long Side Moun ng,
Point Supported
Long Side Moun ng,
Rails Parallel to
Moun ng Frame
Short Side Moun ng,
Point Supported
(End Mount)
Short Side Moun ng,
Rails Parallel to
Moun ng Frame
(End Mount)
Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
par es, unless there is a formal authoriza on by Maxeon.
2 Test loads are for informa on purposes only, design loads should be considered for the project design.
©2023 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this document are subject to change without notice.
402 502 754
638.23 mm
302,77 mm
1100 mm
1808 mm
Measurement Tolerances are +/-3mm for the Length and Width of the module.
A - Ground Holes (4X Ø 4.2mm)
B - Moun ng Holes (4X 9mm (W) x 14mm (L), R4.5mm)
Moun ng Zone
Test Load Design Load
Loca ons
(distance from corner Downward/Upward Downward/Upward
(Pa) (Pa)
in mm)
303 - 617 +2700/-2000
+1800/-1333
+2000/-2000 +1333/-1333
303- 402
+3600/-1600
402 - 502 +5400/-2400
+2000/-1800 +1333/-1200
502 - 754
50 - 402
+2000/-2000 +1333/-1333
+1333/-1600
402 - 502 +2000/-2400
502 - 754 502 - 754 +933/-1200
+1400/-1800
50 - 402 +2800/-1800 +1867/-1200
402 - 502 +2800/-1800 +1867/-1200
+1867/-1200
502 - 754 +2800/-1800
0 - 221 +1400/-1400
+933/-933
221 - 321
+1800/-1200 +1200/-800
+1400/-1400 +933/-933
0 - 221
221 - 321 +1067/-1067
+1600/-1600
754 502
AC Clips
GEN 4.4 FRAME PROFILE
SIDE FRAME PROFILE
30 mm
33 mm
3 In the cases where hybrid moun ng is necessary (combina on of long and short side moun ng), the lowest
design load values should be considered as allowable design load.
4 Bo om flange moun ng
5 Range indicates posi oning of the clamp and not the rails
MAXEON SOLAR TECHNOLOGIES, LTD.
402 50
A
B
END FRAME PROFILE
30 mm
24 mm
537620 Rev.G
13